# A Concrete RV Pad Built for Your Rig, Your Lot and Our Rain

> A concrete RV pad sized for your rig and how you back in, built for the weight and set above standing water. RV pad installation in Baton Rouge.

Canonical page: https://hernandezconcreteworks.com/concrete-construction/concrete-rv-pad-installation

Hernandez Concrete Works (Hernandez Concrete Works LLC) is a family-owned concrete contractor based in Baton Rouge, LA 70817, owned by Gerardo Hernandez. Baton Rouge's family-owned concrete contractor for homeowners who want it done right beneath the surface: honest diagnosis, drainage-first prep, written estimates, and a job site left clean. Insured with general liability and workers' compensation. No foundation repair. Phone (225) 363-8576, Mon to Fri 8am to 6pm, Sat 9am to 1pm, Sun closed.

A concrete RV pad gives your camper, travel trailer or motorhome a flat, dry place to sit instead of sinking into the yard after every storm. Hernandez Concrete Works handles RV pad installation in Baton Rouge and the surrounding parishes, and we build each pad around three things: the size of your rig, the way you actually back it in, and where the water goes when it rains.

## Sizing a concrete RV pad for the rig and the turn

The most common mistake with an RV parking pad is building it to the length of the camper and nothing else. A pad has to fit the rig, the tongue or tow vehicle if it stays hitched, room to open the slide-outs and the door, and enough space to walk around it without stepping into mud.

The other half is the approach. Backing a 30-foot trailer between a fence and a house is not the same as pulling a motorhome straight in off a side street. Gerardo will ask you to show him how you swing in, where the wheels track and where you stop. If the approach crosses soft ground, the pad may need a wider apron at the entrance so you are not cutting ruts beside it every time you park.

- Overall length of the rig, plus the hitch or tow vehicle if it stays attached
- Width with the slide-outs open and the awning out
- The path you back along and where the wheels cross the yard
- Room to walk around it, load it and wash it
- Any plans to upgrade to a bigger rig later

## Picking the spot on the lot

Where the pad goes is as important as how it is built. The side yard next to the garage is the usual choice, but it is not always the best one. We look at the ground for low spots, at the trees nearby and at how close the rig will sit to the house and the property line.

Trees deserve a second look. Tree roots lifting one section is one of the most common causes of cracked concrete Gerardo sees on driveways and sidewalks here, and a pad poured over the root zone of a big oak can be pushed up the same way. Sometimes moving the pad a few feet avoids years of trouble.

We also think about the view from the street and from your back windows, where the sewer or water connection sits if you hook up at home, and whether you will need to get a mower or a trailer past the rig once it is parked.

## Why an RV pad is not just a bigger patio

A loaded camper or motorhome puts a lot of weight on a few small contact points: the tires, the tongue jack and the stabilizers. A thin slab poured for foot traffic can crack under that kind of point load, especially where the tires roll on and off the edge.

So an RV pad is built for the weight. That means a solidly compacted base, a slab thickened for the load, and reinforcement where the weight calls for it, with extra attention at the entry edge where the wheels drop on. We don't quote a one-size-fits-all spec; the pad for a pop-up trailer and the pad for a diesel pusher are not the same pad, and the estimate will say what yours needs and why.

> Heavy wheels on a thin edge is where most pads fail. We build the entry edge for the weight that rolls over it.

## Keeping the rv pad out of standing water

Louisiana averages about 60 inches of rain a year, and a lot of yards that look flat hold water in places you only notice after a storm. Parking an RV in a low spot means wet tires for days, a soft approach and a pad that sits in its own puddle.

Before we set forms, we look at where water collects and where it drains. The pad is set at a height and slope that sheds water off and away from the rig, and away from the house and the neighbor's yard. The Hernandez name has done drainage work on Baton Rouge area properties since 2013 through our sister company, Hernandez Lawnscape, so planning the runoff is part of the pour, not an afterthought.

## Tying an RV parking pad into an existing driveway

Many homeowners want the pad to connect to the driveway they already have, so the rig rolls straight from one to the other. That is often a good option, and it is one of the questions we look at on the site walk.

How it is done depends on the condition and height of the existing driveway. If the old slab is solid, the new pad can be joined to it with a planned joint so the two move independently without a trip edge. If the section where they meet is already cracked or lifted, the honest answer may be to replace that one section first. Gerardo will tell you which it is and quote only what needs doing.

Keep in mind that East Baton Rouge Parish lists an addition to or expansion of a driveway among residential work that needs a permit. If your pad connects to the driveway, check with your permit office before the pour.

## RV pad installation in Baton Rouge: what the week looks like

Most of the work happens before the truck arrives: the walk-through, the layout, digging out the soft material, bringing in and compacting the base, and setting the forms to the slope. The pour itself is the shortest part of the job.

After the pour, wait a full 24 hours before walking on the pad and 5 to 7 days before you park the RV on it. That week matters. Concrete is still gaining strength, and a heavy rig set on a young slab can mark or crack it. The job is finished when the forms are pulled, the leftover concrete and debris are hauled off, and the yard around the pad looks better than before we started.

## What affects RV pad cost

We don't post RV pad prices, because the pad for a small trailer on flat, firm ground and the pad for a large motorhome on a low, soft lot are very different jobs. These are the things that move the number on your estimate:

- Length and width of the pad and any apron at the entry
- How much soft soil comes out and how much base goes in
- Thickness and reinforcement for the weight of your rig
- Grading and drainage to keep the pad out of standing water
- Joining to an existing driveway, and any section that needs replacing first
- Access for the concrete truck and haul-off at the end

## Questions to ask before you hire anyone for a concrete pad for an RV

Most homeowners get two or three quotes, and we think you should. Ask each contractor how thick the pad will be at the edges, how they prepare the base, where the water will go and whether cleanup is included. A lower bid usually saves on overhead, labor and profit, a little of everything, and sometimes on prep you will not see until the pad settles.

We are insured, with general liability and workers' compensation. Gerardo walks every property himself and puts the scope in a written estimate so you can compare it line by line against anyone else's.

A concrete RV pad should be the last thing you think about once it's poured: flat, dry, and strong enough that you never wonder about it. For RV pad installation in Baton Rouge, [Denham Springs](https://hernandezconcreteworks.com/denham-springs), [Central](https://hernandezconcreteworks.com/central) and the towns around them, call (225) 363-8576 and Gerardo will come measure the rig and the turn with you. For the basics that apply to every new pour, see our [concrete slab foundation](https://hernandezconcreteworks.com/concrete-construction/concrete-slab) page.

## Frequently asked questions

### How big should my RV pad be?

Big enough for the rig, the hitch or tow vehicle if it stays attached, the slide-outs and awning when open, and room to walk around it. Many owners also add space at the entrance so the wheels are not cutting into the yard on the turn. Measure your rig, think about the next one, and Gerardo will lay it out with you on the site walk.

### Can you tie a new RV pad into my existing driveway?

Usually, yes. If the existing driveway is solid at the point where they meet, the new pad can be joined with a planned joint so the two slabs move without a trip edge. If that section is cracked or lifted, it may need to be replaced first. Adding to a driveway can need a permit in East Baton Rouge Parish, so check before the pour.

### How long before I can park my RV on a new pad?

Wait 5 to 7 days before parking the RV or anything heavy on it, and a full 24 hours before walking on it. Concrete is still gaining strength in that first week, and setting a heavy rig on it too soon can mark or crack the slab. If you have a trip planned, schedule the pour so the pad has that full week.

### Is an RV pad thicker than a driveway?

An RV pad is built for the weight it will carry, which usually means more thickness and reinforcement than a slab poured for foot traffic, with extra attention at the edge where the wheels roll on. The exact build depends on your rig. A small travel trailer and a large motorhome put very different loads on the concrete, so the estimate spells out what yours needs.

### How much does an RV pad cost?

It depends on the size of the pad, the base work your soil needs, the thickness and reinforcement for your rig, drainage, and whether it ties into a driveway. We do not publish prices because those factors change from yard to yard. Gerardo may give a rough range on the phone, then a written estimate after he walks the site.

### My yard floods. Can I still have an RV pad?

Often, yes, but the pad has to be planned around the water. We look at where water collects and set the pad at a height and slope that sheds rain away from the rig, the house and the neighbors. On some lots that means extra base or grading. If the spot you picked is the lowest point in the yard, we will tell you and suggest a better one.

### Can you build a cover over an RV pad?

Ask Gerardo at the estimate. We build patio covers, and he can talk through whether a cover over your RV pad fits the kinds of covers we build. Either way, if a cover is in the plan, now or later, tell us before the pour so the slab is laid out with the posts and the roof runoff in mind. Our Patio Covers page explains how we plan a slab and a cover together.

## Related pages

- [Concrete Driveway Contractors in Baton Rouge, LA](https://hernandezconcreteworks.com/concrete-construction/concrete-driveway-installation.md)
- [Garage and Shop Pads in Baton Rouge and Livingston Parish](https://hernandezconcreteworks.com/concrete-construction/garage-and-shop-pads.md)
- [Concrete Slab Foundation and Slab Pours in Baton Rouge](https://hernandezconcreteworks.com/concrete-construction/concrete-slab.md)

## Contact

- Hernandez Concrete Works, Baton Rouge, LA 70817
- Phone: (225) 363-8576
- Hours: Mon to Fri 8am to 6pm, Sat 9am to 1pm, Sun closed
- Free written estimate: https://hernandezconcreteworks.com/contact-us
